Dab a bit of glue to the leather, and then wrap a piece of embroidery floss around it.
Measure and cut your leather. Plan the design and burn it on the leather band, I just lined up the diamond design on both side of the word which I burned in the previous step.
If you like this bracelet instructable, please take a moment to vote for me in the "Bracelet Challenge". Try again...
Yes No. As a matter of fact, when you're wrapping embroidery floss around a leather strip to make a friendship bracelet, you should never knot the floss, because it doesn't look as nice.
Knot the ends. Tell us more about it?
Repeat the same step by starting on the R thread first. Use the x-acto knife to cut small slits where the prongs indented the leather.How to Make a Leather Celtic Knot Bracelet
April 5, 2016 at 12: Begin your braid. It was so smooth and it felt like I was using a marker pen for writing on the leather. A polished look can be accomplished by using leather chord.
However, you never move the strip that's currently in the center when you're making a braid.
To create the clasp, add the snap-on buttons to either end of the bracelet. We had so much fun filming this video. Edit Related wikiHows.
Embossed Brown Regaliz Leather Bracelet. To create a leather cuff, you will need strips of tooled leather, leather glue, a leather needle, waxed linen thread, and a button snap or clasp for the ends of the bracelet. Finish your braid. There are tons of Glue and Go findings that will suit the look you want too.