How to connect double coil subwoofer

Brought to you by Techwalla. If the dual VC was 2x 4 ohm, that would give 2 ohm; if the SV is 4 ohm, you add the 2 to get 6 ohm.

Check to see which two terminals are used for bridge mode on your amplifier.

How to Wire a Dual 4 Ohm Subwoofer in Parallel for a 2 Ohm Load

Single Voice Coil Vs. Next, connect the negative end of the first coil to the positive end of the second coil. By using this service, some information may be shared with YouTube. Learn more...

Single Voice Coil Vs. Dual Voice Coil Subwoofers

If it is capable of driving powering low impedance loads, then it can be done. Now comes the easy part.

how to connect double coil subwoofer

Nice write up man. Answer 3 months ago.

how to connect double coil subwoofer

Then, take the other end of this piece and insert it into the second negative terminal. Photo Credits.

Connect the wire from the second sub's negative terminal to the negative bridge terminal on the amp. If you are wiring the coils in parallel then run a wire from the first positive terminal to the second positive terminal and a wire from the first negative terminal to the second negative terminal.

Series wiring is using one amplifier with several subwoofers; independent wiring is using one coil per channel.

how to connect double coil subwoofer

Take the Kicker SW1220 speaker wire and cut two separate pieces of the blue positive wiring; one 1' piece and one 2' piece. Co-Authored By:.

The Kicker CVX subwoofer will be loaded inside of the vented box. Reply Upvote. Because the woofer is a Dual 4 ohm we are going to have to connect the two terminals on the subwoofer. Run a wire to connect the negative terminal of the second coil in your second sub to the negative bridged terminal of the amp.

Use the positive from channel 1 and the negative from channel 2 to one of your subs.

Double Coil Woofer 12" Repairing