Making rosary beads instructions how to tie

Cut the twine and melt the ends using a lighter. Place it perpendicular to the vertical part of the cross and place the cross on top of it.

making rosary beads instructions how to tie

Once your knot is in the position you want it, pull both ends of the twine evenly and tighten the knot. Learn more...

making rosary beads instructions how to tie

Wrap the twine around your pointer finger 3 times. Remove the loops from your pointer finger by sliding them off and gripping them between your pointer finger and your thumb. Tie one 3-loop knot on either side of the S-loop knot.

Making a Knotted Rosary

Upload a picture for other readers to see. A good rosary can be prayed with eyes closed. Learn more. Tie the knot the same way as you did before, except wrap the twine around your finger 4 times instead of 3.

To create this article, volunteer authors worked to edit and improve it over time. Hold out your left hand at the end of the one foot of twine away from the end. Make sure these knots are touching and are as tight as possible. Stop the current step you are on, and untangle the twine.

making rosary beads instructions how to tie

Allow the last knot to rest on the second crease on your finger. Push this knot up right against the last 3-loop knot Tighten as much as possible.

making rosary beads instructions how to tie

Cut the end of thread that was not used to make the cross. Cut the twine into segments approximately 20 feet long. Include your email address to get a message when this question is answered. Take the remaining long piece of twine that is not knotted and fold it in half.

making rosary beads instructions how to tie