How to make a metal melter

How to Make the Metal Melter

But the Amps are closer to 800!! Make sure you're familiar with the dangers of opening a microwave, because there are components inside that may still carry a charge and could hurt, or even kill you.

how to make a metal melter

Question 10 months ago on Step 5. Check them out at www. I made one and it hums quite a bit and it throws loud sparks instead of turning red hot and melting. I'm a hobbyist blacksmith and this would be awesome to use if it could be modified somehow for forging.

Brandonoutdoors 2 years ago. By The King of Random www. Recirculating Air Spray Booth. If you don't have a way to weld the base back on, you can use some 2-part epoxy-glue and apply to all the surfaces that will be in contact. Ok, your transformer core should now be bare. Question 1 year ago on Step 6. DavidW785 Question 10 months ago on Step 5.

I used my bench vise as a clamp and it worked perfectly! I Made It! A hacksaw, or angle grinder can be used to cut the weld, then a hammer and chisel used to break it open, giving you access to the primary and secondary coils. Jramos89 2 years ago.

how to make a metal melter

The next step is to carefully replace the primary coil, an ensure it's snug at the bottom of the core. Can you please tell me what power supply i would i use on this unit?

how to make a metal melter

That's enough current to melt iron nails and steel bolts on contact! This tool is good, can melt much of the metal? This thicker cable will extend the amount of time a massive electrical current can flow before the cable overheats.

how to make a metal melter

Would a cable with a higher ampacity heat up slower during use than one with a lower rating?