Dew rag how to make

Unfold the remaining fabric and lay it onto the flat surface again.

Sew the pressed-under edge of the tie to the inside of the cap section. Now,take the side head pieces and place them in front of you on a flat surface with the decorative sides of the fabric face up.

dew rag how to make

This is the tie section. You will be cutting through two layers of fabric.

Pin the tie on along the straight edge around the bottom of the cap. For the middle head piece: Morris writes for various websites and private clients. Line up the other side head piece on the opposite side of the tail piece in the same way but in a mirror image of what you just did. Now take the two bottom corners of the fabric with your fingers and fold the fabric up squarely to a point just wide enough to accommodate the pattern piece. Make a shoe lace key ring How To: From points 10, 11 and 12 measure out the same way but only?

dew rag how to make

Cut out the fabric along the remaining lines of the pattern. Fix and clean the bobbin case area on your own sewing machine How To: Add 1 inch.

How to Make a Dew Rag

Measure out a perpendicular line from point 9 by? Measure from the center of your forehead around one side of your head to the nape of your neck. Thread a bobbin on a side threading sewing machine How To: The second rectangle you drew needs a few adjustments to complete pattern piece that will be used to cut the portion of the doo rag that covers the crown of your head:.

dew rag how to make

Arrange the tape measure in a half-circle, using the measurement from Step 3, and ending on the other end of the straight line. Maneuver the right edge of the tail piece and line it up with the arc of the side head piece, pinning it as you go, until you reach the end of the arc.

Mark that point number 7. Fold the tie section in half widthwise to find its center. Continue sewing the pressed-under edges together along both free ends of the tie section.

MAKE A BANDANA SKULL CAP : SEWING HOW TO LIFE HACK ~ Artismia

Lay the end of the tape measure on one end of the straight line you drew in Step 2. This step is optional if you would like a stronger double-faced tie. Tie or sash: